Small Business Proxy Server

If you're facing issues where Selenium WebDriver (using JUnit) is not able to locate elements that were detectable by Selenium IDE, there could be a few reasons for this discrepancy. Here are some common troubleshooting steps:

1. Timing Issues

Selenium WebDriver might execute commands faster than Selenium IDE, leading to timing issues. Add explicit waits in your WebDriver script to ensure that the elements are present or visible before interacting with them.

import org.openqa.selenium.By;
import org.openqa.selenium.WebDriver;
import org.openqa.selenium.WebElement;
import org.openqa.selenium.support.ui.ExpectedConditions;
import org.openqa.selenium.support.ui.WebDriverWait;

// ...

WebDriverWait wait = new WebDriverWait(driver, 10);

// Example: Wait for an element to be clickable
WebElement element = wait.until(ExpectedConditions.elementToBeClickable(By.id("yourElementId")));
element.click();

2. Different Browser Profiles

Selenium IDE may use a different browser profile or settings compared to your WebDriver script. Ensure that the browser profile and settings are consistent.

3. Synchronization Issues

Elements might not be fully loaded or rendered when WebDriver tries to locate them. Add proper synchronization mechanisms to wait for the page to be ready.

4. Browser Window Size

Ensure that the browser window size in Selenium WebDriver is suitable for the elements to be visible. Use the manage().window().maximize() method to maximize the browser window.

driver.manage().window().maximize();

5. JavaScript Execution

Selenium IDE may execute JavaScript differently than WebDriver. If your website relies heavily on JavaScript, ensure that WebDriver handles JavaScript appropriately.

6. Switching to Iframes

If the elements are inside iframes, make sure to switch to the correct iframe using driver.switchTo().frame() before interacting with the elements.

7. Browser Console Logs

Check the browser console logs for any error messages or warnings that might indicate issues with JavaScript or other resources.

System.out.println(driver.manage().logs().get("browser").getAll());

8. CSS Selectors and XPath

Selenium IDE may use different selectors than your WebDriver script. Double-check the selectors (CSS or XPath) used in your WebDriver script.

9. Browser Extensions

Selenium IDE may have browser extensions installed that affect the behavior of the web page. Ensure that WebDriver runs in an environment that mimics the configuration used by Selenium IDE.

10. Headless Mode

If Selenium IDE is running in headless mode, try running your WebDriver script in headless mode as well to replicate the environment.

If the issue persists after considering these points, you may want to inspect the HTML source of the page and compare it with the recorded script in Selenium IDE to identify any differences.

In Windows 8 and later editions it is recommended to setup network proxy through Group Policy. To do this, run GPMC.msc (via "Run" or enter in the "Search"), then select the section with the users, from the list of parameters select "Internet Settings". Further settings are not different from the standard ones in Windows. You can set proxy, specify the start page, enter restrictions and so on.

In Windows 10 you need to go to "Settings", go to "Network and Internet", open the tab "Proxy" and make the necessary settings for the connection (under "Manual", the item should also be made active).

There are lots of ways to use them. For example, you can swap your real IP address location for an American one, thus getting the opportunity to watch Netflix at a bargain price. Or you can set up parsing traffic through a proxy to test the security of your web applications. Or you can create a proxy server on your local network that allows traffic through and blocks requests to certain sites.

Open the "Browser Properties" in the control panel, in the "Connections" section of the opened window select "Network Settings". Remove the check mark from the "Use proxy" item, click "OK".